Call for Contributions

This section needs improvements, examples and explanations.

Please take a look at the Contributing Guide for our Write Documentation.

VPP Configuration

VPP settings consist of several main sections.

Main Dataplane settings and internal VPP interfaces:

• VPP Dataplane Core Configuration
• VPP Interfaces Configuration

Features that can be enabled on VPP Dataplane:

• VPP ACL Configuration
• VPP IPsec Configuration
• VPP NAT Configuration
• VPP sFlow Configuration

VPP Initialization

When VPP Dataplane is configured and the configuration is committed, VyOS will attempt to start VPP and initialize all interfaces assigned to it. During this process the following steps occur:

1. VyOS checks that the system meets all requirements for VPP operation. If any requirement is not met, VPP will not start and an error message will be displayed.

2. VPP is started and its initial configuration is applied.

3. All interfaces assigned to VPP are initialized and brought up.

4. A special virtual interfaces are reinstalled to the kernel with the same names as interfaces that were attached to VPP to maintain compatibility with the configuration.

5. VyOS configuration initializes those virtual interfaces, so that features that exist only in kernel dataplane continue to operate.